Filter
Top Products
Add/Cancel Devices [1.A]
This option allows the engineer to add and remove
wirefree detectors to and from the system.
Adding Devices
Devices are added to the system as follows:
1. Ensure that "E/MENU 1" is selected.
2. Press [A] to select the add/cancel devices
option.
3. Press [A] to add a new device.
4. The display will prompt you to enter the device
number (01 - 30). Enter the device number
and press [ENT].
5. The display will sow "SHOW LED", align the
activity LED of the detector or remote setting
device with the learn sensor on the main PCB
(top right hand corner).
6. Trigger the detector by operating the tamper
or pressing a button on the remote setting
device.
7. The activity LED flashes and transmits a unique
identity code to the learn sensor. The control
panel will give a rising multi-tone sound and
the display will show the device type learnt:
8. FOB = 502r watch pendant
FIRE = 509r smoke detector
PIR = 515r PIR
KEY FOB = 525r remote setting device
DOOR CON = 535r universal transmitter
9. Press [ENT] to continue. If required, repeat from
step 3 for other devices or press [ESC] to leave
this programming option.
☞
If you enter a device number that is
currently being used by another
detector the display shows "* IN USE*"
when selecting the device at step 4.
☞
If you try to learn the same device twice
the display will show "*ON SYS*" when
triggering the detector at step 6.
Removing Detectors
Devices are added to the system as follows:
1. Ensure that "E/MENU 1" is selected.
33
TS690R Installation Manual Engineer’s Menu 1
Enter the device
number 01 - 30.
Align the detector LED
with the learn sensor on the
control panel and trigger
the detector by activating
the tamper.
The display will show the
type of device learnt
A
= Add devices
A
E / MENU 1
AD D / CANX
DEV ? --
SH OW LED
PIR
KEY FOB
DOOR CON
FOB
FIRE
Add devices Flowchart