Filter
Top Products
525r Remote Setting Device
The 525r remote setting device can be used to
set, part set (part set A only) and unset the alarm
system. In addition, pressing the "ARM" and "OFF"
at the same time will cause a panic alarm. The
525r is assigned as a detection circuit.
Learning
See "Adding Devices" on page 33.
Changing the Battery
The battery used in the 525r is a Duracell DL 1/3N or
CR 1/3N or K58L (Alkaline). The battery can be
obtained from normal high street stockists.
1. Undo the screw holding down the battery
compartment cover.
2. Slide back the cover.
3. Replace the battery (make sure the battery
polarity is correct).
4. Replace the cover and tighten the screw.
Installing a 535r Universal Transmitter
The 535r universal transmitter is designed to work
with the TS690R control panel. The transmitter
signals an alarm when the associated magnet
moves away from the case, and sends a restore
signal when the magnet is re-aligned.
Siting the 535r Universal Transmitter
Where possible, mount the unit close to the top of
the non-moving frame of a door or window, and
the magnet on the moving part. If the frame is not
wide enough, mount the magnet on the frame
and the unit on the moving part.
17
TS690R Installation Manual System Installation
-ve Terminal
+ve Terminal
Battery
Terminal
Block
Internal
Reed
Internal Reed
Shunt Link
Fixing
Hole
Fixing
Hole
Tamper
Bar
Back
Battery
Case
Tamper
Body
+
+
Activity LED
PANIC
5
ARM
NIGHT
OFF
Activity LED
Part set button