Filter
Top Products
TS690R
I/D Selector Circuit A Circuit B
Panel
Output
1 31 32 5
2 33 34 6
3 35 36 7
4 37 38 8
ENG/NULL N/A N/A N/A
l
No two remote keypads or LECs should
have the same I/D.
5. If the remote keypad has a "ENT" key
enabled/disable link it can be used to limit the
functionality of the remote keypad. If the "ENT"
key is enabled the remote keypad can be
used to set/unset and access all user menus. If
the "ENT" key is disabled the remote keypad
can only be used to set and unset the system.
6. Finally clip the remote keypad cover onto the
base being careful not to trap any cables or to
obstruct the tamper switch.
TS700 LEC Installation
The TS700 LEC (Local Expansion Card) is
connected to the “Remote Network” and provides
two additional programmable detection circuits
and a programmable output. The “Remote
Network” may have up to three LECs connected,
as the system will always require at least one
remote keypad.
☞
Always ensure that all power (mains and
battery) is removed before making any
connections to the LEC.
1. Remove the cover from the base and carefully
remove the PCB.
2. If the LEC is being fitted inside the control panel
you may remove the LEC PCB from its base
and secure it to base of the control panel using
self adhesive feet. If required, the tamper
switch may also be disabled by fitting the
jumper link across JP2, see Figure 8.
3. If the LEC is being fitted outside the control
panel, hold the base in position and mark the
two securing holes. Drill and plug the wall, then
pass all cables into the base via the cable
entry points. Secure the base to the wall using
the appropriate fixing screws.
4. Connect “Remote Network” cables and
detection circuit cables to the appropriate
terminals, see Figure 8.
5. Set the I/D selector jumper link to the required
position:
TS690R
I/D Selector Circuit A Circuit B
Panel
Output
1 31 32 5
2 33 34 6
3 35 36 7
4 37 38 8
ENG/NULL N/A N/A N/A
l
No two LECs or remote keypads should
have the same I/D.
6. Finally clip the LEC cover onto the base being
careful not to trap any cables or to obstruct the
tamper switch.
13
TS690R Installation Manual System Installation
Network
connections
Programmable
output
switched -ve
@100mA
Tamper switch
Fit jumper-link to
disable tamper switch
CABLE ENTRY
CABLE ENTRY
Programmable
detection circuits
I/D selector
CCT B
E D
C
B
LEC I/D
A
1 2 3 4
JP2
TAMPER= JP2 NOT FITTED
NO TAMPER= JP2 FITTED
CCT A
TATB
ZA
ZB
O/P
Figure 8. TS700 Remote Arming Keypad Layout