Filter
Top Products
42 Sun StorEdge Availability Suite 3.2 Software Troubleshooting Guide • December 2003
Related Error Messages
The Solaris configuration administration utility, cfgadm, reports an error when it is
used on systems where the Sun StorEdge Availability Suite software is installed. The
error occurs because a process does not suspend properly so that the cfgadm
operation can proceed. The error message has the following format:
cfgadm: Hardware specific failure <operation> failed: could not
suspend user process <process_id>
You must stop the process manually, perform the cfgadm operation, and then start
the process again. Use the following commands to accomplish this:
1. Quiesce I/O to the sets, using the following series of commands:
2. Issue the cfgadm command.
3. Start I/O to the sets, using the following series of commands:
/etc/init.d/rdc stop
/etc/init.d/ii stop
/etc/init.d/sv stop
/etc/init.d/scm stop
/etc/init.d/scm start
/etc/init.d/sv start
/etc/init.d/ii start
/etc/init.d/rdc start
/etc/init.d/rdcfinish start