Filter
Top Products
Chapter 3 Error Messages 23
Cannot enable %s:%s ==> %s:%s,
secondary in use in another set
Kernel A set being enabled or resumed has a secondary
volume that is already in use as a secondary volume
for another remote mirror set. A volume cannot be
enabled as a secondary volume if it is already in use as
a secondary volume by another remote mirror set.
Cannot enable master volume
PITC iiadm attempted to put the master volume under SV
control during an enable operation, but failed.
Cannot enable shadow volume
PITC iiadm attempted to put the shadow volume under SV
control during an enable operation, but failed.
Cannot reverse sync %s:%s <==
%s:%s, set is in queuing mode
Kernel A reverse sync has been requested on a set that is in
queuing mode. Put the set into logging mode and then
the issue the reverse sync command for the set.
Change request denied, don’t
understand request version
Kernel A request was sent from one remote mirror host to the
other, and the version of the software was not
understood by the receiving host. Verify that both
hosts are running compatible versions of the remote
mirror software.
Change request denied, volume
mirror is up
Kernel The user asked to sync a remote mirror set, and the
secondary host has refused the sync event.
changing queue parameters may only
be done on a primary SNDR host
RM The queue parameters for the async I/O queue, both
memory-based and disk-based, can be changed only
on the primary host.
Cluster list access failure
PITC iiadm was unable to retrieve a list of cluster groups
from the kernel. Possible errors:
EFAULT: The kernel module tried to read out-of-
bounds. File a bug against iiadm
ENOMEM: The kernel module ran out of memory.
cluster name is longer than <MAX>
characters
RM The cluster resource tag is too long for the remote
mirror software to accept.
config error: neither <host1> nor
<host2> is localhost
RM The current host is neither the primary nor secondary
host for the remote mirror set. Verify that the hostname
of the system has not been changed since the remote
mirror set was enabled.
TABLE 3-1 Error Messages for the Sun StorEdge Availability Suite 3.2 Software (Continued)
Error Message From Meaning