Filter
Top Products
22 Sun StorEdge Availability Suite 3.2 Software Troubleshooting Guide • December 2003
cannot find SNDR set
<shost>:<svol> in config
RM Remote mirror set cannot be found in the configuration
database. The set is not configured. Check the entry for
errors.
Cannot reconfig %s:%s to %s:%s,
Must be in logging mode
Kernel An operation has been requested that requires the
remote mirror set to be in logging mode. Put the
remote mirror set into logging mode and then request
the reconfiguration.
Cannot reconfigure sync/async on
members of a group
Kernel The user attempted to reconfigure the mode of a set
that is in a group. The set must be removed from the
group before its mode can be reconfigured.
cannot replace disk queue <diskq1>
with <diskq2>
RM Look at check_diskqueue(cfg, qvol, group_arg);
can not start reverse sync as a
file system is mounted on <vol>
RM The primary volume has a file system mounted on it.
Unmount the file system on the primary volume and
then issue the reverse sync command.
can not start sync as SNDR set
<shost>:<svol> is not logging
RM The remote mirror set must be in logging mode on the
primary host before a sync can be started. If the
primary site is in an error state, fix the error and then
place the primary site into logging mode for this set.
Then reissue the forward sync command.
can not use current config for
bitmap reconfiguration
RM A single set must be specified for bitmap operations.
The default configuration cannot be used for these
operations.
can not use current config for
disk queue operations
can not use a config file for disk
queue operations
RM An individual set or group must be specified when
issuing disk queue operations. A single disk queue
operation cannot operate on all sets configured or all
sets in a file.
can not use current config for
enable command
RM A set must be specified when issuing an enable
command. An enable command cannot operate on the
default configuration.
Can't export a mounted volume
PITC A volume cannot belong to a mounted file system
before it is exported.
Can't get memory for list enquiry
PITC iiadm ran out of memory.
Can't open sort program
PITC The iiadm operation is attempting to sort output
before displaying it but cannot find the sort utility
(typically found in /usr/bin/sort).
TABLE 3-1 Error Messages for the Sun StorEdge Availability Suite 3.2 Software (Continued)
Error Message From Meaning