Sun Microsystems 3.2 Water System User Manual


 
28 Sun StorEdge Availability Suite 3.2 Software Troubleshooting Guide December 2003
Enable failed
PITC Could not enable volume. Possible errors:
EFAULT: The kernel module tried to read out-of-
bounds. File a bug against iiadm.
ENOMEM: The kernel module ran out of memory.
DSW_ESHUTDOWN: The kernel module is in the process
of shutting down the point-in-time copy software. No
new sets can be enabled.
DSW_EEMPTY: One of the volumes' names (master,
shadow, bitmap) is blank. File a bug against iiadm.
DSW_EINUSE: One of the volumes (master, shadow,
bitmap) is already being used by another set.
DSW_EOPEN: Failed to open one of the volumes
(master, shadow, or bitmap).
DSW_EHDRBMP: Could not read bitmap header. Bitmap
volume might be inaccessible or bad.
DSW_EOFFLINE: One of the volumes (master, shadow,
bitmap) is offline and cannot be made part of a set.
DSW_ERSRVFAIL: Could not get access to the
underlying volume (master, shadow, bitmap).
Enable failed, can't tidy up cfg
PITC Could not enable volume and could not remove new
entry from configuration file.
Enable pending on %s ==> %s, try
again later
Kernel A previous enable operation of a set is still processing
when another enable operation is attempted.
enabling disk queue on an SNDR
secondary is not allowed (<diskq>)
RM A disk queue can be added only to a set on the
primary site.
Export failed
PITC Could not export the shadow of the specified set.
Possible errors:
EFAULT: The kernel module tried to read out-of-
bounds. File a bug against iiadm.
ENOMEM: The kernel module ran out of memory.
DSW_EEMPTY: No set was specified to export from.
DSW_ENOTFOUND: The specified set does not exist in
the kernel.
DSW_EDEPENDENCY: The set is not independent.
DSW_ERSRVFAIL: Could not access the bitmap header
to record the export operation.
Failed to allocate memory
PITC iiadm ran out of memory.
TABLE 3-1 Error Messages for the Sun StorEdge Availability Suite 3.2 Software (Continued)
Error Message From Meaning