Sun Microsystems 3.2 Water System User Manual


 
34 Sun StorEdge Availability Suite 3.2 Software Troubleshooting Guide December 2003
Reverse sync needed, cannot sync
%s:%s ==> %s:%s
Kernel The user requested a forward sync operation for a
remote mirror set which needs a reverse sync. This
occurs when a previous reverse sync does not
complete successfully or because the primary volume
was damaged and had to be replaced. Issue a reverse
sync for the set.
%s:%s ==> %s:%s already has a disk
queue attached
Kernel A set cannot contain more than one disk queue. To add
a new disk queue, remove the old disk queue first. The
disk queue replace command can also be used to
accomplish this task.
%s:%s has invalid size
(%s)..cannot proceed
Kernel The remote mirror software could not determine the
size of the secondary volume. Verify that the
secondary volume is not in an error state and can be
accessed.
%s:%s ==> %s:%s is already enabled
Kernel The user attempted to enable a remote mirror set using
the same secondary volume and secondary host as a
remote mirror set that is already enabled. Specify a
different secondary volume or secondary host for the
new set.
%s ==> %s not already enabled
Kernel The user has tried to do an operation on a set that is
not enabled. Verify that the proper set has been
specified to sndradm and then verify that the set is
enabled using sndradm -i.
Set Copy Parameters failed
PITC iiadm could not modify the copy units and delay
values for the specified set. Possible errors:
EFAULT: The kernel module tried to read out-of-
bounds. File a bug against iiadm
ENOMEM: The kernel module ran out of memory.
DSW_EEMPTY: No set was specified for the parameters
DSW_ENOTFOUND: The specified set was not found in
the kernel.
EINVAL: The delay or units value is out of range.
set <shost>:<svol> neither sync
nor async
RM The mode of the set specified in the configuration file
is incorrect. This occurs whenthe user inserts a set into
the configuration manually, using dscfg with an
incorrect mode tag.
set <shost>:<svol> not found in
config
RM The specified set is not in the current configuration.
Use sndradm -i to verify that the set is in the current
configuration.
Shadow and bitmap are the same
device
PITC During an enable operation, iiadm discovered that the
shadow volume and the bitmap volume are the same.
TABLE 3-1 Error Messages for the Sun StorEdge Availability Suite 3.2 Software (Continued)
Error Message From Meaning