Filter
Top Products
36 Sun StorEdge Availability Suite 3.2 Software Troubleshooting Guide • December 2003
SNDR set does not have a disk
queue
RM Set does not have a disk queue attached when
attempting either a queue remove operation or a queue
replace operation.
SNDR: The volume ’<vol2>’ has been
configured previously as ’<vol1>’.
Re-enter command with the latter
name.
RM The user attempted to enable a set in which the
volume was already enabled, but with a different
name.
SNDR: ’<vol1>’ and ’<vol2>’ refer
to the same device
RM A physical device cannot be used for more than one
volume in the remote mirror set.
Stat failed
PITC Possible errors:
EFAULT: The kernel module tried to read out-of-
bounds. File a bug against iiadm
ENOMEM: The kernel module ran out of memory.
DSW_EEMPTY: No volume name was specified
DSW_ENOTFOUND: Could not find specified volume in
kernel.
SV-disable failed
PITC iiadm tried to perform svadm -d on a volume. See
the ds.log file for more information.
SV-enable failed
PITC iiadm tried to perform svadm -e on a volume. See
the ds.log file for more information.
Target of copy/update is mounted,
unmount it first
PITC If the shadow in a master-to-shadow copy or update
operation or the master in a shadow-to-master copy or
update operation is mounted, it cannot be copied to.
The bitmap %s is already in use
Kernel The bitmap requested for the remote mirror set being
enabled is already in use as a bitmap for another set.
Enable the set and specify a different volume for the
bitmap.
The remote state of %s:%s ==>
%s:%s prevents this operation
Kernel The user attempted to do a sync or reverse sync while
the secondary volume is mounted. First unmount the
secondary volume and then issue the sync or reverse
sync request.
The state of %s:%s ==> %s:%s
prevents this operation
Kernel The set the user is attempting to sync is part of an
advanced configuration. The state of one of the other
sets in the configuration prevents this sync from
occurring for one of the following reasons:
• Another set in a one-to-many configuration is
currently doing a reverse sync.
• A reverse sync is being requested for a set in a one-
to-many configuration and at least one of the other
sets is not in logging mode.
• A set is already syncing.
TABLE 3-1 Error Messages for the Sun StorEdge Availability Suite 3.2 Software (Continued)
Error Message From Meaning