Filter
Top Products
20
Prior to Entries
Preparations for Entries
■ Receipt and journal paper rolls
If the receipt and journal paper rolls are not set in the machine or there are low rolls, install new ones
according to section “Installing and Removing the Paper Rolls” under “Operator Maintenance.”
■ Receipt ON/OFF function
You can disable receipt printing in the REG mode to save paper using the receipt function. To disable
receipt printing, press the
M
key and select RCP SW. from the menu to select an option, OFF. When the
function is in the OFF status, the receipt off indicator “R” is highlighted.
Your register will print reports regardless of the receipt state. This means that the receipt roll
must be installed even when the receipt state is “OFF”.
■ Cashier assignment
Prior to any item entries, a cashier must enter his/her cashier codes into the POS terminal. Follow the
procedure shown below.
To sign on:
To sign off:
• If another cashier is signed on while a cashier is signed on, the latter will automatically be
signed off.
• If you want to enter a cashier code before every transaction, consult your authorized SHARP
dealer.
• Your POS terminal can provide the cashier + clerk system or the clerk only system instead of
current system (cashier only system). If you want to change the system, please consult your
authorized SHARP dealer.
Clerk assignment
To sign on:
To sign off:
˚
Clerk code Secret code
(In case of secret code is 0000)
through
CLK
1
CLK
10
˚˚
NOTE
NOTE
CASH
#
Cashier code Secret code
(In case of secret code is 0000)
through
CASH
1
CASH
10
CASH
#
CASH
#
NOTE
3