Filter
Top Products
196
Options
List of Options
For your UP-600 POS terminal, the following options are available:
For details, contact your authorized SHARP dealer. Do not try to install any options yourself.
1. RAM memory board model UP-S02MB, UP-S04MB
2. Remote drawer model ER-03DW, ER-04DW or ER-05DW
3. Magnetic card reader model UP-E13MR
4. Remote customer display model UP-P16DP (Pole type)
5. EFT terminal I/F model ER-01EF
6. Two-port RS-232 interface model ER-A5RS
7. Inline communication model UP-E10IN
8. Barcode reader model ER-A6HS1
9. Expand key kit ER-11KT7, 12KT7 and 22KT7
10. Dummy key kit ER-11DK7G and 51DK7G
15
Before Calling for Service
The malfunctions shown in the left-hand column below, labeled “Fault,” do not necessarily indicate
functional faults of the machine. It is therefore advisable to refer to the “Checking” shown in the right-hand
column before calling for service.
• The display won't be illuminated even when the
mode switch is turned to any other position than
“”.
Fault Checking
• Is power supplied to the electric outlet?
• Is the power cord plug out or loosely connected to
the electrical outlet?
• Is the power switch in the “ON” position?
• Are the contrast control adjusted correctly?
• Is the terminal in screen-save mode?
• No receipt is issued.
• No journal paper is taken up.
• Printing is unusual.
• Is the receipt paper roll properly installed?
• Is there a paper jam?
• Is the receipt function in the “OFF” status?
• Is the print head release lever at the printing
position?
• Is the take-up spool installed on the bearing
properly?
• Is there a paper jam?
• Is the print head release lever at the printing
position?
• Is the paper roll properly installed?
• The display is illuminated, but the whole machine
refuses entries.
• Is a cashier code assigned to the POS terminal?
• Is a clerk code assigned to the POS terminal?
• Is the mode switch set properly at the “REG”
position?