Filter
Top Products
20 C540M-C (10/05)
DIRECT CAMERA CONTROL FOR NON-PELCO MUX
In the Direct Camera Control Menu, COM 3 has a default of NONE. You can select and configure the following MUX types: Montage, Robot,
and Drax.
Figure 22.
Direct Camera Control (Non-Pelco MUX)
1. Select to go down to COM 3.
Figure 23.
COM Port
2. Select or to select the MUX type.
Figure 24.
MUX Type
NOTE:
Be careful when selecting and saving a MUX. You cannot change your selection without first recycling power on the keyboard.
3. Select to go down to the “Cam per MUX” line.
Figure 25.
Cameras Per Multiplexer
4. Select .
5. Enter a number for the number of cameras to be connected to the MUX. Figure 25 shows 16 cameras.
6. Select again.
7. Select and then .
Direct Camera Control
COM 1
COM 2
COM 3
Cam Per Mux
>
PELCO
PELCO
None
16
SAVE
Direct Camera Control
COM1
COM2
COM3
Cam Per Mux
>
PELCO
PELCO
None
16
SAVE
Direct Camera Control
COM1
COM2
COM3
Cam Per Mux
>
PELCO
PELCO
Robot
16
SAVE
Direct Camera Control
COM1
COM2
COM3
Cam Per Mux
>
PELCO
PELCO
Robot
16
SAVE