Filter
Top Products
Telephone Features 3-39
3.2 Telephone Features C
Conditions
• If the destination extension does not answer the call within a pre-determined time
(default: 30 seconds), “Transfer Recall” occurs.
• If there is no answer within thirty minutes after “Transfer Recall” starts, the line will be
disconnected.
• When the dialed extension is busy, you may access the extension by dialing “2” (Busy
Station Signaling) or “3” (Executive Busy Override) and going on-hook.
• If you want to return to the held call, press the TRANSFER button or corresponding
CO or INTERCOM button before the destination extension answers.
• When “Transfer Recall” occurs, the display will show the following:
<Example>
• A flexible CO button can be assigned as a DSS button.
• To use “One-Touch Transfer”, System Programming is required.
• If you want to return to the held call, flash the hookswitch before the destination
extension answers.
• If “Hold-3” is assigned in System Programming, you must dial “20” after flashing the
hookswitch.
Programming References
• Station Programming (Section 2)
Flexible Button Assignment — Direct Station Selection (DSS) Button
• System Programming — Installation Manual
[005] One-Touch Transfer Using a DSS Button
[104] Hold Mode Selection
[201] Transfer Recall Time
Feature References
Call Transfer, Screened – to Extension (→ See the Installation Manual.)
Call Transfer, Unscreened – to Extension (→ See the Installation Manual.)
One-Touch Transfer Using a DSS Button (→ See the Installation Manual.)
SLT
SLT
PT
PT
RCL: Ext 101
PT
PT