Filter
Top Products
Telephone Features 3-21
3.2 Telephone Features C
Conditions
• To retrieve a call on hold at another extension, refer to “Call Hold Retrieve” in this
manual.
• If a held call is not retrieved within a pre-determined time (default: 30 seconds), “Hold
Alarm/Hold Recall” occurs. If the hold recall time is set to “Disable”, it will not be
recalled.
• If a held outside call is not answered within thirty minutes, it will be automatically
disconnected.
• When going off-hook:
— Before recalling: A dial tone will be heard while the call is on hold. You may dial
another telephone number.
— While recalling: Only the first call on hold will be released and enter the
conversation mode.
• You cannot hold a doorphone call.
• With outside calls, you can put multiple calls on hold. However, with intercom calls,
you can put only one call on hold. One way around this is to use the Call Park feature.
See page 3-30.
• If a call is placed on hold for more than the programmed time, ringing or an alarm tone
will be heard (Hold Recall/Hold Alarm) and the following displays will be shown.
While the alarm tone is being sent, the LCD will flash.
Example:
— When holding extension 111, Mr. Brown: “111: Brown” will be displayed.
— When holding outside (CO) line, CO 1: “Call on CO 1” will be displayed.
• If “Hold-2” or “Hold-3” is assigned by System Programming, you must dial “20” after
flashing the hookswitch.
• Only an outside or intercom call can be placed on hold at one time.
If you want to hold both calls, use the Call Park feature.
Programming References
• System Programming — Installation Manual
[104] Hold Mode Selection
[200] Hold Recall Time
Feature References
Call Hold Retrieve
Call Park
Hold Alarm/Hold Recall (→ See the Installation Manual.)
SLT
SLT
PT
PT