Filter
Top Products
Ceiling & Floor, Ceiling Suspended (50Hz, R22) 89
16. Function of Remote Controller
The remote control transmits the signals to the system.
START/STOP BUTTON
Operation starts when this button is pressed
and stops when the button is pressed again.
OPERATION MODE SELECTION BUTTON
Used to select the operation mode.
ROOM TEMPERATURE
SETTING BUTTONS
Used to select the room temperature.
INDOOR FAN SPEED SELECTOR
Used to select fan speed in four steps
low, medium, high and CHAOS.
JET COOL
Used to start or stop the speed cooling/heating.
(Speed cooling/heating operates super high fan speed.)
CHAOS SWING BUTTON
Used to stop or start louver movement and
set the desired up/down airflow direction.
ON/OFF TIMER BUTTONS
Used to set the time of starting and stopping operation.
TIME SETTING BUTTONS
Used to adjust the time.
TIMER SET/CANCEL BUTTON
Used to set the timer when the desired time is obtained
and to cancel the Timer operation.
SLEEP MODE AUTO BUTTON
Used to set Sleep Mode Auto operation.
AIR CIRCULATION BUTTON
Used to circulate the room air without cooling or heating.
ROOM TEMPERATURE CHECKING BUTTON
Used to check the room temperature.
RESET BUTTON
Initialize remote controller.
2nd F Button
Used prior to using modes printed in blue at the bottom
of buttons.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
Remote Control
AUTO CLEAN
ON
OFF
CANCEL
SET
Cooling Operation
Auto Operation
Healthy Dehumidification Operation
Flip-up door
(opened)
Heating Operation
Signal transmitter
•
Cooling Model( ), Heat Pump Model( )
5
1
3
10
9
12
14
6
4
2
7
11
8
13
Operation Mode
(Heat Pump)
(Cooling Only)
For VK/VL Chassis Models