LevelOne WBR-3460 Door User Manual


 
Wireless ADSL2/2+ Modem Router User Guide
86
Remote VPN
Endpoint
Select the desired option (IP address or Domain Name) and
enter the address of the remote VPN endpoint you wish to
connect to.
Note: The remote VPN endpoint must have this VPN Gate-
way's address entered as its "Remote VPN Endpoint".
NETBIOS Enable
Check this if you wish NETBIOS traffic to be forwarded over
the VPN tunnel. The NETBIOS protocol is used by Microsoft
Networking.
Local LAN
Local LAN
This identifies which PCs on your LAN are covered by this
policy. For each selection, data must be provided as follows:
Single address
Enter an IP address in the "IP address" field. Typically, this
setting is used when you wish to make a single Server on
your LAN available to remote users.
Subnet address
Enter an IP address in the "IP address" field, and the de-
sired network mask in the "Subnet Mask" field.
The remote VPN endpoint must have these IP addresses
entered as its "Remote" addresses.
Remote LAN
Remote LAN
This identifies which PCs on the remote LAN are covered by
this policy. For each selection, data must be provided as
follows:
Single PC - no subnet
Select this option if there is no LAN (only a single PC) at
the remote endpoint. If this option is selected, no additional
data is required.
Single address
Enter an IP address in the "IP address" field. This must be
an address on the remote LAN. Typically, this setting is
used when you wish to access a server on the remote
LAN.
Subnet address
Enter an IP address in the "IP address" field, and the de-
sired network mask in the "Subnet Mask" field.
The remote VPN endpoint must have these IP addresses
entered as its "Local" addresses.
ESP Configuration
SPI
Enter the required SPIs. Each policy must have unique SPIs.
These settings must match the remote VPN endpoint. Note
that the "in" setting here must match the "out" setting on the
remote VPN endpoint, and the "out" setting here must match
the "in" setting on the remote VPN endpoint.