LevelOne WBR-3460 Door User Manual


 
Wireless ADSL2/2+ Modem Router User Guide
84
Local Identity
Type
Select the desired option to match the "Remote Identity
Type" setting on the remote VPN endpoint.
WAN IP Address - your Internet IP address.
Fully Qualified Domain Name - your domain name.
Fully Qualified User Name - your name, E-mail address,
or other ID.
Local Identity
Data
Enter the data for the selection above. (If "IP Address" is
selected, no input is required.)
Remote Identity
Type
Select the desired option to match the "Local Identity Type"
setting on the remote VPN endpoint.
IP Address - The Internet IP address of the remote VPN
endpoint.
Fully Qualified Domain Name - the Domain name of the
remote VPN endpoint.
Fully Qualified User Name - the name, E-mail address, or
other ID of the remote VPN endpoint.
Remote Identity
Data
Enter the data for the selection above. (If "IP Address" is
selected, no input is required.)
SA Parameters
Encryption
Encryption Algorithm used for both IKE and IPSec. This
setting must match the setting used on the remote VPN
Gateway.
Authentication
Authentication Algorithm used for both IKE and IPSec. This
setting must match the setting used on the remote VPN
Gateway.
Pre-shared Key
The key must be entered both here and on the remote VPN
Gateway. This method does not require using a CA (Certifi-
cate Authority).
SA Life Time
This determines the time interval before the SA (Security
Association) expires. (It will automatically be re-established if
necessary.) While using a short time period (or data amount)
increases security, it also degrades performance. It is com-
mon to use periods over an hour (3600 seconds) for the SA
Life Time. This setting applies to both IKE and IPSec SAs.
Enable PFS (Per-
fect Forward
Secrecy)
If enabled, security is enhanced by ensuring that the key is
changed at regular intervals. Also, even if one key is broken,
subsequent keys are no easier to break. (Each key has no
relationship to the previous key.)
This setting applies to both IKE and IPSec SAs. When con-
figuring the remote endpoint to match this setting, you may
have to specify the "Key Group" used. For this device, the
"Key Group" is the same as the "DH Group" setting in the IKE
section.