LevelOne WBR-3460 Door User Manual


 
Wireless ADSL2/2+ Modem Router User Guide
18
6. On the final screen of the Wizard, run the test and check that an Internet connec-
tion can be established.
7. If the connection test fails:
Check all connections, and the front panel LEDs.
Check that you have entered all data correctly.
Configuring VC2, VC3 and VC4
The Wireless ADSL2/2+ Modem Router supports multiple VCs (Virtual Circuits) on the
ADSL connection.
VC1 must be used for general-purpose Internet access. The other VCs (VC2, VC3
and VC4) are available for special purposes, such as Video-on-Demand.
You can only use these VCs if supported by your ISP and ADSL service provider. In
that case, they will provide the necessary configuration data.
Some ISP's allow multiple PPPoE connections. This allows
multiple PCs to connect to the Internet using PPPoE client
software. When using the Wireless ADSL2/2+ Modem Router,
multiple PPPoE connections are neither necessary nor sup-
ported.
To Configure additional VCs
1. Start the Setup Wizard again.
2. On the first screen, select VC2, and click "Next"
3. Configure the VC setup screen as described below, then click "Next".
Figure 8: Setup Wizard - VC2