LevelOne WBR-3460 Door User Manual


 
Installation
11
ADSL2/2+ Modem Router and the PCs.
Also, if using multiple Access Points, adjacent Access
Points should assign different Channels.
2. Connect LAN Cables
Use standard LAN cables to connect PCs to the Switching Hub ports on the Wire-
less ADSL2/2+ Modem Router. Both 10BaseT and 100BaseT connections can be
used simultaneously.
If required, connect any port to a normal port on another Hub, using a standard
LAN cable. Any LAN port on the Wireless ADSL2/2+ Modem Router will automati-
cally function as an "Uplink" port when required.
3. Connect ADSL Cable
Connect the supplied ADSL cable from to the ADSL port on the Wireless
ADSL2/2+ Modem Router (the RJ11 connector) to the ADSL terminator provided
by your phone company.
4. Power Up
Connect the supplied power adapter to the Wireless ADSL2/2+ Modem Router.
Use only the power adapter provided. Using a different one may cause hardware
damage.
5. Check the LEDs
The Power LED should be ON.
The Status LED should flash, and then turn Off. If it stays on or blinking after 60
seconds, there is a hardware error.
For each LAN (PC) connection, one of the LAN LEDs should be ON (provided the
PC is also ON.)
The WLAN LED should be ON
The ADSL LED should be ON if ADSL line is connected.
The Internet LED may be OFF. After configuration, it should come ON.
For more information, refer to
Front-mounted LEDs in Chapter 1.