LevelOne WBR-3460 Door User Manual


 
Setup
21
LAN Screen
Use the LAN link on the main menu to reach the LAN screen. An example screen is
shown below.
Figure 10: LAN Screen
Data - LAN Screen
TCP/IP
IP Address
IP address for the Wireless ADSL2/2+ Modem Router, as seen
from the local LAN. Use the default value unless the address is
already in use or your LAN is using a different IP address range.
In the latter case, enter an unused IP Address from within the
range used by your LAN.
Subnet Mask
The default value 255.255.255.0 is standard for small (class "C")
networks. For other networks, use the Subnet Mask for the LAN
segment to which the Wireless ADSL2/2+ Modem Router is
attached (the same value as the PCs on that LAN segment).
DHCP Server
If Enabled, the Wireless ADSL2/2+ Modem Router will
allocate IP Addresses to PCs (DHCP clients) on your LAN
when they start up. The default (and recommended) value is
Enabled.
If you are already using a DHCP Server, this setting must be
Disabled, and the existing DHCP server must be re-
configured to treat the Wireless ADSL2/2+ Modem Router
as the default Gateway. See the following section for further
details.
The Start IP Address and Finish IP Address fields set the
values used by the DHCP server when allocating IP Ad-
dresses to DHCP clients. This range also determines the
number of DHCP clients supported.
See the following section for further details on using DHCP.