Filter
Top Products
Additional Calibration Information
C-22 September 2000
Editing Information on the Procedure Tab
The Procedure tab contains general configuration attributes as shown and
described below. The values displayed in the example are the default settings.
Procedure
Attribute
Description
Graphing Instructs the application when to display the graphs of the data
Tolerance Level Indicates whether the level of tolerance is Normal, Loose, or Strict
Out of Tolerance Provides the flexibility to interact at each step or to use a fully
automated calibration
Maximum Cycles Indicates the maximum number of iterations the calibration
procedure will perform if “Out of Tolerance” is set to “Automatically
iterate up to maximum cycles.”.
Processor In Control Indicates whether the Processor In Control dialog box is to be
displayed at the beginning of the calibration process