Filter
Top Products
Diagnostics and Troubleshooting
September 2000 5-25
1101 Density DMIN/DMAX points
are invalid.
Density points are invalid. Reread density values on
densitometer or make a new
calibration print.
1102 Density data is not
monotonic increasing.
Density data is invalid. Reread density values on
densitometer or make a new
calibration print.
1103 Exceeded maximum number
of allowable data errors.
Density data is invalid. Reread density values on
densitometer or make a new
calibration print.
1104 Asymmetric Density
Groupings are invalid.
Density data is invalid. Reread density values on
densitometer or make a new
calibration print.
1201 Unknown response from
densitometer.
The application received an
unknown response from the
densitometer during
initialization.
Verify that the baud rate of the
densitometer matches the
applications configuration.
1202 Error:_error_from
densitometer.
Unexpected error was returned
from the densitometer.
Calibrate the densitometer. If the
problem continues, check the
manual for the densitometer.
1203 Error: Number of patches
seen by densitometer is
incorrect.
Unable densities on densitometer. Try adjusting frame counts or
reread the density patches on the
densitometer.
1300 Values have not been loaded Matrix file missing. Create a new device.
1301 Data or Matrix files have not
yet been loaded
Matrix file missing. Create a new device.
1302 Data cannot be saved, must
first apply the matrix
Matrix file missing. Create a new device.
Error
Code
Error Code /Status
Message
Possible Cause/Subsystem Possible Solution