Filter
Top Products
Threading the Machine
• Threading the Machine
* Raise the thread take-up lever to its highest
position by turning the handwheel
counterclockwise.
* Raise the presser foot lifter.
* Place a spool on the spool pin, with thread coming
off as shown.
(_ Draw the end of thread around the upper thread
guide.
(_ While holding the thread near the spool, draw the
end of the thread down around the check spring
holder.
(_ Firmly draw the thread up from right to left over
the take-up lever and down into the take-up lever
eye.
(_ Slide the thread behind the needle bar thread
guide on the left.
(_ Thread the needle from front to back or use a
needle threader.
We recommend using the convenient needle
threader(#200262101), included with your
machine.
I- l 1
• Drawing up Bobbin Thread
O Raise the presser foot. Hold the needle thread
lightly with your left hand and rotate handwheel
counterclockwise for one complete turn.
(_ Bring the bobbin thread up by pulling the needle
thread up.
Pull both threads under and to the back of the
presser foot, leaving 4 to 6" (10 to 15cm)
of thread clear.
-<
J
26