Filter
Top Products
10.3 Telephone Number Entries / Connection Commands
TELn=
Set telephone entry n to ...
(default, blank)
Twenty telephone numbers can be stored in memory.
Format: TEL2=01044617944965
If the MODEM or ISDN Terminal Adapter is to work in the DIRECT
mode, the entry can be left blank.
Telephone number 0 is the default number dialled when alarms are
used to initiate a call to another system. The fall back number if this is
engaged is always stored in telephone number 1.
Where a number is used with dual ISDN dialling it is automatically linked with that
number plus 10. Therefore Tel number 4 & 14 would be dialled if dual ISDN was
selected for that telephone number.
TELn
Set telephone entry n as current
This selects the number that will be dialled initially if the up/down keys
are not used to select another.
Format: TEL2
TYPEn=
Set telephone entry type to dial via ISDN0, ISDN1,
ISDNx2 (dual), or MODEM
(default, ISDN0)
Each of the telephone numbers can be linked to either a PSTN
MODEM or an ISDN terminal adapter.
This command determines which of the external ports (MODEM, ISDN
Port0, or ISDN Port1) will be used when a particular telephone number
is selected.
Format:
TYPE0=ISDN0
TYPE1=ISDN1
TYPE2=ISDN2
TYPE3=MODEM
TYPE4=MODEM2
Example: TYPE5=2
Sets Telephone entry 5 to ISDN2
Dedicated Micros Ltd Page 45
DVST Installation Guide Calls