Filter
Top Products
SYNC
The sync or synchronous mode relies on the modem generating clock
signals to the DVST.
MODEM
Modem switches from the command mode CMD> to allow direct
control of a connected MODEM. The speed of communication with the
MODEM will be as set with the MBAUD= command.
This is called transparent MODEM mode and is terminated by
pressing the ESCAPE or ESC key.
MBAUD=
Set MODEM port ASYNC baud rate.
(default, 19200)
9600, 19200, 38400
This command sets the speed of communication between the DVST
and the MODEM when AUX 1 is used for asynchronous mode. The
speed of communication in the Synchronous mode is determined by
the clock signal supplied by the MODEM.
ASYNC
In the asynchronous mode the MODEM controls the flow of data using
RTS/CTS signals.
MODEM2
Modem switches from the command mode CMD> to allow direct
control of a connected MODEM through AUX 1. The speed of
communication with the MODEM will be as set with the PORT=
command.
This is called transparent MODEM mode and is terminated by
pressing the ESCAPE or ESC key.
PORT=
AUX1, 19200, N 8 1, MODEM2
Refer Chapter Setup (Basic).
Page 18 Dedicated Micros Ltd
Modems DVST Installation Guide