Filter
Top Products
5.3 Remote Setup
Remote DVST units can also be set up in the same manner as a local DVST. The same
procedure should be followed when the DVST is on line to a remote unit. When the
SETUP key is pressed the screen will go blank and the command prompt REM> will
appear on screen.
Proceed as for the local system.
Note: A PC cannot initiate remote set up with the “+++” command.
5.4 DVST Commands
Most commands are typed in direct and terminated by pressing the <ENTER> key on a
PC.
HELP
Lists all commands available.
Note: Paragraphs 4.6 onwards detail the command information listed by the help option and
have been grouped together in the logical order that should be used when setting up a
DVST system.
QUIT
Exits the SETUP mode.
This returns the DVST to normal operation. If a MODEM is connected
and the DVST is set to MODEM=ON the initialisation strings will be
sent to the MODEM.
RESET
Resets DVST to factory defaults
This command is used to completely reset the DVST system.
(All values are reset to their default values.)
Note: These values are stored in an integrated circuit called an EEPROM. This is not
dependent on a battery backup and will retain its settings indefinitely without a power
supply.
VIEW
Display current DVST settings
This will display all the current DVST settings.
Page 10 Dedicated Micros Ltd
Setup DVST Installation Guide