Filter
Top Products
10 Calls
10.1 Passwords
Passwords can be set and used by the system. When a PASSWORD is set it provides
protection for the system at two points:
1) Whenever a remote system calls it must send the correct password, otherwise
no connection will be established.
2) Whenever the SETUP key is pressed, the password will be requested before
the setup mode is entered.
Method:
Enter SETUP mode is by pressing the SETUP key on either keyboard.
If a password has been set the screen will go blank and the prompt PASSWORD
will appear on the screen. At this point a valid password must be entered followed
by pressing the <ENTER> key. If this entered correctly the prompt CMD will
appear on screen.
PASSWORD=
Set system password to ...
The system password can be up to 10 alpha numeric, case sensitive,
characters. Once this has been set only calling units that have the
associated password linked to the telephone number can access the
system.
PASSn=
Set telephone entry n password to ...
Range is 0 to 19
This is linked to the designated telephone number and is the keyword
that will unlock the remote system that is being called. It may be up to
10 alpha characters in length.
Format: PASS4=BERLIN
In the above case the system called would have the password set to
BERLIN. Only then could the system be accessed.
Default: None set
Dedicated Micros Ltd Page 43
DVST Installation Guide Calls