Filter
Top Products
7.11 OCTOCOM OSI 8196A
Cable required to connect to DVST 25to25 (Part No. AS-DVST-SYNC)
Manufacturer:
Octocom Systems, Inc.
One Executive Drive
Chelmsford,
MA 01824
USA
No DIP switches are used.
A single DATA push button on the front panel serves to unhook the
modem.
When the modem is unpacked and used for the first time the CD line
is held on. This means that the DVST unit believes that there is an
incoming call and waits for data.
Proceed as follows to clear this condition:
Wait for the DVST unit to time out
and then press <SETUP>
At the command prompt CMD> typeMINIT= <RET>
At the command prompt CMD> type SREG= <RET>
At the command prompt CMD> type USER=AT <RET>
At the command prompt CMD> type SEND <RET>
Wait for the information to be sent to the modem.
At the command prompt CMD> type MODEM <RET>
The unit will reply - Modem Mode
Type AT <RET>
The reply from the modem is “OK”
Type in the following, AT&M1&C1&D2&K0&R1<RET>
The reply from the modem should be “OK”, if the reply
is “ERROR”, try again.
Type AT&W
The modem will now power up without the CD line held on.
Press the <ESC> key to exit modem mode.
At the command prompt CMD> type. MINIT=&M1 &C1 &D2 &K0 &R1.
&M1Dial async, switch to sync on connect.
&C1CD follows remote carrier.
&D2 Hangs up with on to off transition of DTR - needed for auto answer.
&K0Modem flow control is disabled.
&R0Modem iignores RTS, CTS is on when the modem is online.
Dedicated Micros Ltd Page 29
DVST Installation Guide Modems