Filter
Top Products
11-7
VPN 3002 Hardware Client Reference
OL-1893-01
Chapter 11 Policy Management
Configuration | Policy Management | Traffic Management | PAT | Enable
PAT Enabled
Check the box to enable Client Mode (PAT), or clear it to enable Network Extension Mode.
Note Remember that to use Network Extension Mode, you must configure an IP address other than the
default for the private interface. If you do not change the IP address of the private interface, you can
not disable PAT.
Apply/Cancel
To enable or disable PAT, and include your setting in the active configuration, click Apply. The Manager
returns to the Configuration | Policy Management | Traffic Management | PAT screen.
Reminder:
To save the active configuration and make it the boot configuration, click the Save Needed icon at the
top of the Manager window.
To discard your entry and leave the active configuration unchanged, click Cancel. The Manager returns
to the Configuration | Policy Management | Traffic Management | PAT screen.