Filter
Top Products
Date: 8-4-2010
Revision: 0
Form: 2396
2.2.5 STATUS PAGE
►
Figure 14 Status Page
The status page (Figure 14) is displayed when a
boiler is selected on the Home page. The status
page displays the current condition of the boiler
and displays some of the more important
configuration settings. The boiler name is
displayed in the title bar of the status page.
NOTE:
When the boiler has no name defined, the
display will use the Modbus address to identify
the boiler.
The standard status page displayed for the
Triple-flex boiler contains summary status
information as shown in Figure 14. Any status
information not applicable for the installation is
blanked out on the screen. Buttons on this
screen include:
Configure:
Used to configure the R7910 (see “Configuration
Page” 2.2.6 page 18 for more details).
Operation:
Used to perform daily/frequent functions with the
R7910, such as setpoint adjustment, etc. (See
“Operation Page” 2.2.11 page 22 for more
details.)
Diagnostic:
Used to view R7910 diagnostic information.
Details:
Used to view boiler detail status information.
History:
Used to view R7910 history.
Modulation:
Used to toggle between two different status
displays: modulation, and setpoints.
2.2.6 CONFIGURATION PAGE
► ►CONFIGURE
Figure 15 Configuration Menu Page
The configuration page allows the user to view
and set parameters that define how the boiler
functions in the hydronic heating system.
Configuration parameters for any boiler
connected in the Global Modbus™ network can
be accessed from the display. Press the boiler’s
button on the Home page to acess the Status
page. Pressing the Configure button on the
status page starts a configuration session. The
configuration page contains a menu of
parameters grouped into functional areas that
the user selects for configuration (see Figure
15).
18
No specific order for configuring the boiler is
required. All parameters are enabled for editing,
though some may not be applicable (e.g., a
configuration parameter may disable a boiler
feature). Selecting a parameter group from the
menu displays parameters exclusively