Filter
Top Products
D9112B | Program Entry Guide | 3.0 User Interface EN | 58
Bosch Security Systems | 2/04 | 74-06145-000-D
Bypass a Pt
Default: P
Selection: Blank, E, or P
Bypass a Point [COMMAND] [0]: Bypass points in
areas within the
Scope
of the command center
where the function is entered (see Cmd Cntr
Assignment). Bypassed points do not respond to faults.
See Command Center Function Selections in the
introduction to the Command Center Functions
programming module for descriptions of selections.
L## Bypass a Pt
Default: See
Program Record Sheet
Selection: Blank or E
Bypass a Point: See Authority Level Selections in the
introduction to the Authority Lvl Assign programming
module for descriptions of selections.
Unbypass a Pt
Default: P
Selection: Blank, E, or P
Unbypass a Point [COMMAND] [0] [0]: Unbypass
points in areas within the
Scope
of the command
center where the function is entered (see Cmd Cntr
Assignment). When unbypassed, a point can detect
faults and respond according to programming.
See Command Center Function Selections in the
introduction to the Command Center Functions
programming module for descriptions of selections.
L## Unbypass a Pt
Default: See
Program Record Sheet
Selection: Blank or E
Unbypass a Point: See Authority Level Selections in
the introduction to the Authority Lvl Assign
programming module for descriptions of selections.
Reset Sensors
Default: E
Selection: Blank, E, or P
Reset Sensors [COMMAND] [4] [7]: Activate the
Reset Sensors function in areas within the
Scope
of
the command center where the function is entered
(see Cmd Cntr Assignment). See Relays section for
information about Reset Sensors relay activation.
See Command Center Function Selections in the
introduction to the Command Center Functions
programming module for descriptions of selections.
L## Reset Sensors
Default: See Training Sheet
Selection: Blank or E
Reset Sensors: See Authority Level Selections in the
introduction to the Authority Lvl Assign programming
module for descriptions of selections.
Relay Control
Default: P
Selection: Blank, E, or P
Relay Control [COMMAND] [5] [4]: Manually
operate relays installed in the D9112 system. This is
a panel-wide function that can be executed from
any command center assigned to an area where the
user has authority. See the D9112 Operation and
Installation Manual for information about optional
relays.
See Command Center Function Selections in the
introduction to the Command Center Functions
programming module for descriptions of selections.
L## Relay Control
Default: See
Program Record Sheet
Selection: Blank or E
Relay Control: See Authority Level Selections in the
introduction to the Authority Lvl Assign programming
module for descriptions of selections.
Remote Program
Default: P
Selection: Blank, E, or P
Remote Programming [COMMAND] [4] [3]:
Initiate Remote Account Manager (RAM) sessions.
This is a panel-wide function that can be executed
from any command center assigned to an area where
the user has authority. Reports concerning the
remote programming session are generated as Area
1 events.
See Command Center Function Selections in the
introduction to the Command Center Functions
programming module for descriptions of selections.