Filter
Top Products
D9112B | Program Entry Guide | 2.0 Area Wide Parameters EN | 31
Bosch Security Systems | 2/04 | 74-06145-000-D
A# Area O/C
An
Area
Opening
report is sent to the central station when each individual area is opened (disarmed). An
Area
Closing
report is sent to the central station when each individual areas is closed (armed). This report includes the
area information.
Default: Yes
Selection: Yes or No
Yes
Generate
Area
Opening
and
Closing
reports for this area. Do NOT use this selection if the panel
reports to an automation system that cannot interpret multiple Area
Opening
/
Closing
reports.
Whether
Area
Opening
and
Closing
reports are sent or not depends on two factors:
Authority Level Assignment: The first factor is the authority level of the passcode entered. If a
passcode is required to arm or disarm, and the Authority Lvl Assign program item
L## Area O/C
is
disabled for the user’s authority level, the report is not sent. See the User Interface Authority Lvl Assign
section,
L## Area O/C prompt
.
Note:
If a passcode is not required for arming or disarming and this item is YES, the area sends Opening and
Closing reports. Since there is no need to enter a passcode, there is no authority level screening to prevent the
report from being sent.
Opening/Closing Window: The second factor is whether or not an opening or closing “window” is
in effect at the time of the opening or closing. When a window is in effect, programming in
Disable
O/C in Window
determines whether or not the report is sent.
No
Do not generate
Area
Opening
and
Closing
reports for this area.
Use this selection if the panel reports to an automation system that cannot interpret multiple
Area
Opening
/
Closing
reports, or if
Modem Format
is programmed to NO in the Phone category (BFSK
Format is in use and
Opening
and
Closing
reports are enabled).
Note:
Even if
L## Area O/C
is Enabled for the authority level of the passcode used to arm or disarm, openings
and closings are not reported by area when this item is NO.
Programming this item NO does NOT prevent Account Opening and Closing reports if they are enabled
in
A#Acct O/C
.