Filter
Top Products
D9112B | Program Entry Guide | 1.0 Panel Wide Parameter EN | 23
Bosch Security Systems | 2/04 | 74-06145-000-D
RAM Call Back
Used to add an additional level of communication security to RAM sessions.
Default: No
Selection: Yes or No
Yes When the D9112 hears the proper RAM passcode, it hangs up the phone, seizes the phone line, then
dials the programmed RAM phone number (see
RAM Ph
). This ensures that the D9112 only
communicates with RAM units connected to the programmed phone number.
No The RAM session is initiated immediately. No call back is required. The D9112 can engage in RAM
sessions when called from any phone number and a proper RAM passcode is identified.
RAM Line Monitor
Enables an answering machine work-around.
Default: Yes
Selection: Yes or No
Yes When a telephone answering machine is programmed to pick up the phone before the D9112, the
panel listens for RAM lead-in tone. If the RAM tone is identified, the panel seizes the phone line
from the other device and begins a RAM session.
You must program
Answer Armed
and/or
Answer Disarmed
and the panel must be in the
proper armed state.
If
RAM Call Back
is programmed YES, the panel hangs up on the phone after the RAM tone and
a proper RAM passcode is identified, then it calls the RAM phone number.
No The item should be programmed NO if you are not using RAM.
This item should be programmed NO if the panel is not sharing the phone line with an answering
machine.
This item should be programmed NO if it causes false seizures of the phone line. (This indicates a
device using the same frequency tone is also using the phone line to which the panel is connected.)
Answer Armed
Set telephone ring counter to answer when all areas
are master armed. If any area in the panel is
perimeter armed or disarmed, the
Answer
Disarmed
ring counter is used.
Default: Blank
Selection: 1 to 15, or Blank
Blank No answer.
1 to 15 The D9112 answers the phone after
the specified number of rings when
all areas are master armed.
Note:
Perimeter armed is considered a disarmed state for this
prompt.
Answer Disarmed
Set telephone ring counter to answer when any area
is in a perimeter armed or disarmed state.
Default: Blank
Selection: 1 to 15, or Blank
Blank No answer.
1 to 15 The D9112 answers the phone after the
specified number of rings when any
area in the system is in a perimeter or
disarmed state.
Note:
Perimeter armed is considered a disarmed state for this
prompt.