Filter
Top Products
D9112B | Program Entry Guide | 1.0 Panel Wide Parameter EN | 24
Bosch Security Systems | 2/04 | 74-06145-000-D
Ram Ph
The phone number the panel dials to contact RAM.
The panel dials the programmed number as a result
of the following events:
•
Log % Full
threshold is achieved
• The panel is contacted by RAM and
RAM Call
Back
is programmed YES
• Command 43 is initiated and the user selects the
CALL RAM option
Once in contact with RAM, RAM issues instructions
to the panel. (See the RAM II Operation and
Installation Guide for further information on call pick-
up procedures.)
When dialing the RAM phone number, the D9112
immediately makes two attempts to reach the RAM.
If the D9112 does not reach the RAM on the first
two attempts, it waits ten min. then tries eight more
times with a ten min. interval between each attempt.
One hour after the last failed attempt, the D9112
starts dialing the RAM phone number again. It
immediately makes two more attempts then waits
ten min. and tries eight more times with ten min.
intervals between each attempt before generating a
Bad Call to RAM
report and abandoning the effort.
Note:
Command 43 Dialing Exception: When dialing the
RAM phone number in response to the Command 43
CALL RAM option, the D9112 makes only one
attempt. If it does not make contact with RAM, the
panel abandons the effort and creates a Bad Call to
RAM report.
The D9112 is pre-programmed with a seven sec. dial
tone detect period. When dial tone is detected or the
waiting period ends, the D9112 begins to dial. To
extend the pause or dial tone detect, program a C
and/or D before the prefix/area code.
Enter up to 24 of the characters in the following
table to define dialing characteristics:
Default: Blank
Selection: Up to 24 characters
0 to 9 Numbers zero through nine
C Three sec. pause
D Seven sec. dial tone detect
# or * Used for the same purpose as pressing
this key on a telephone keypad when
manually dialing. For example, an
asterisk (*) may be needed to access
your long distance service.
Blank Panel does not dial a phone number for
RAM. Use Blank when the panel is
connected directly to the RAM modem
(Demo Mode: the panel seizes the line
then waits for instructions from RAM).