Filter
Top Products
50 AVWorks Installer/User Guide
5. Add up to four SNMP management entities to monitor this appliance or leave
this blank to allow any station to monitor the appliance.
a. Click the Add button to defi ne an allowable manager. The Allowable
Manager dialog box appears.
b. Type in the IP address of the management station to add.
c. Click OK to add a management station.
6. Add up to four SNMP trap destinations to which this appliance will send
traps in the Trap Destination fi eld.
a. Click the Add button to defi ne a trap destination. The Trap Destina-
tion dialog box appears.
b. Type in the IP address of the trap destination to add.
c. Click OK to add a trap destination.
7. Click OK to save the settings and close the window.
-or-
Click Apply to save the settings and remain in the open window.
-or-
Click Cancel to exit the window without saving.
Enabling individual SNMP traps
An SNMP trap is a notification sent by the appliance to a management station
indicating that an event has occurred in the appliance that may require further
attention. You can specify what SNMP traps are sent to the management
stations by simply clicking the appropriate checkboxes in the list. When you
select the Traps category for the first time, the AMP will retrieve and display a
list of SNMP traps from the appliance. You may select Enable All or Disable All
to easily select or deselect the entire list.
Figure 4.6: Traps Dialog Box