Filter
Top Products
Setup and Configuration
25
ENV-VST-C - Operation / Reference Guide
9. Use the navigation buttons to select the time of day (AM/PM) which you want these settings to take effect, and
press Mode/Select.
10. Repeat steps 5 through 10 for each appropriate section of the day.
11. Use the navigation buttons to select Dehumidify, and press Mode/Select.
12. Use the navigation buttons to indicate the new dehumidify settings, and press Mode/Select.
13. Use the navigation buttons to select Humidify, and press Mode/Select.
14. Use the navigation buttons to indicate the new humidify settings, and press Mode/Select.
Copying Programmed Settings
To make it easier to program the thermostat, you can create settings for one day and copy the settings to every following
day for the entire week. Perform the following steps to copy programmed settings:
1. On the Program screen, use the thermostat to set the times and setpoints for a full day. See the Establishing
Daytime/Nighttime Temperature Settings section on page 24 for more information.
2. Use the navigation buttons to select Copy To, and press Mode/Select. The settings for the next day of the week
appear (FIG. 27).
3. Use the navigation buttons to select the day of the week to which you want to copy the settings, and press Mode/
Select. A green check mark appears next to the day you select. Repeat this step for every other day to which you
want to copy the settings.
4. Use the navigation buttons to select Done, and press Mode/Select. The thermostat copies the settings to all the
selected days. You can verify this on the Program screen by highlighting Next Day and pressing Mode/Select to
view the settings for each day in the week.
You can only set the Humidify and Dehumidify settings if you have the Humidification
System and Dehumidification System options turned on in the Advanced Setup
options. See the Advanced Setup Screen section on page 39 for more information.
FIG. 27 Copy To screen