Filter
Top Products
95
Mixer, Submix 1 to 8, Out 1,2 to Out 15,16. The outputs that are not available in your audio
hardware will show up as greyed out. If a loaded project has outputs routed that don’t exist on
your audio hardware, these will shown in red.
This can be done in Program Mixer mode by clicking on the arrow above the first insert effect
slot.
Click on the SEND button of the desired channel. Click on one of the SEND knobs of the desired
channel and edit its value with your computer mouse. Alternatively, you can use your mouse scroll
wheel.
 To use a Pad send effect, you have to load an effect into the corresponding send effect slot to
the right of the Track Mixer.
Master effects:
The following paragraph explains how to load and edit Master effects.
X To load a master insert effect, press SHIFT + SEQ EDIT/EFFECTS on your MPC hardware.
First press the F1 (Master) button and after that click on the F4 (Insert) button. Use the cursor
to navigate to the desired insert effect slot. With the -/+ buttons you can open an additional
display page to select the desired effect type. Click F4 (Select) to load the selected effect, or
click F3 (Back) to close the Select Effect display page.
X To load an send effect for the Master chain, click on the F5 button (Send). Use the cursor to
navigate to the desired send effect slot. With the -/+ buttons you can open an additional
display page to select the desired effect type. Click F4 (Select) to load the selected effect, or
click F3 (Back) to close the Select Effect display page. Use the cursor to navigate to the
desired send level. Use the data dial or -/+ buttons to change the Send Level.
In the MPC software, click on the Track Mixer tab in the Upper section. The Master effect section
is located on the right end of the Track Mixer.
Click on the arrow of the master insert effect slot you want to assign an effect to. A pop-up menu
lets you choose from a palette of various effects, which can be loaded directly. Click on a loaded
effect name to open its graphic user interface for more detailed editing. These can be used to
apply effects such as Compressor Master or Transient Shaper to finalize your entire mix.