A SERVICE OF

logo

Open as PDF
next previous
2-145
Catalyst 6500 Series Switch Command Reference—Release 8.4
OL-6244-01
Chapter 2 Catalyst 6500 Series Switch and ROM Monitor Commands
clear snmp trap
clear snmp trap
To clear an entry from the SNMP trap receiver table, use the clear snmp trap command.
clear snmp trap {rcvr_addr} [all]
Syntax Description
Defaults The default configuration has no entries in the SNMP trap receiver table.
Command Types Switch command.
Command Modes Privileged.
Examples This example shows how to clear an entry from the SNMP trap receiver table:
Console> (enable) clear snmp trap 192.122.173.82
SNMP trap receiver deleted.
Console> (enable)
Related Commands set snmp trap
show port counters
test snmp trap
rcvr_addr IP address or IP alias of the trap receiver (the SNMP management station) to clear.
all (Optional) Specifies every entry in the SNMP trap receiver table.