Filter
Top Products
9
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
Tools Needed:
INSTALLATION
3
Top Bracket
Power Drill
7/16” Socket Driver
7/16” Wrench
NOTE: For door section identification see page 5.
NOTE: Refer to illustrations (A) or (B) to determine
which top bracket was supplied with your door.
Follow the corresponding step below:
FOR TOP BRACKET (A): Align upper-center hole of
the top bracket base with #6 hole in the end stile
(See End Stile Hole Pattern on Pg 8). Ensure the top
bracket base is level and aligned with the edge of
the section. Secure the top bracket assembly to the
endstile using (4) 1/4” - 20 x 7/8” self drilling screws.
Insert a short shaft roller into the top bracket slide.
The top bracket slide will be adjusted and tightened
in Step 14. Repeat for the opposite side.
FOR TOP BRACKET (B): Align upper-center hole of
the top bracket base with #6 hole in the end stile
(See End Stile Hole Pattern on Pg 8). Ensure the top
bracket base assembly is level and aligned with the
edge of the section. Secure the top bracket assembly
to the endstile using (4) 1/4” - 14 x 7/8” self drilling
screws. Loosen the 5/16” - 18 nut on the top bracket
assembly. Insert a short shaft roller into the top
bracket slide. The top bracket slide will be adjusted
and tightened in Step 15. Repeat for the opposite
side.
NOTE: For windload specification option codes 1124,
1125, 1142 and 1144, do not insert a short shaft
roller.
NOTE: If you have windload specification option
codes 1124, 1125, 1142 and 1144: Two top bracket
assemblies and a long shaft roller are required
(C). Loosen the 5/16” - 18 nut on the top bracket
assembly and position it flush against the stile,
and centered on the stile. Insert a long shaft roller
through both slides of the top bracket assembly’s
to align. Secure the top bracket assembly to stile
using (4) 1/4” - 20 x 7/8” self drilling screws. The top
bracket slides will be adjusted and tightened in Step
14. Repeat for other side.
(A)
Stile
Top bracket
assembly
Long shaft roller
(1124 / 1125 /
1142 / 1144 only)
(1) 5/16”- 18 x
5/8” Carriage bolt
and (1) 5/16”- 18
hex nut
(4) 1/4”- 14 x 7/8”
Self drilling screws
(1) 5/16”- 18 x 5/8”
Carriage bolt and (1)
5/16”- 18 hex nut
(C)
End
stile
Top
section
Short shaft
roller
Top
bracket
assembly
#6 hole
Center
hole
(4) 1/4”- 14 x 7/8”
Self drilling screws
(1) 5/16”- 18 x 5/8”
Carriage bolt and (1)
5/16”- 18 hex nut
(B)
Top bracket
base
(4) 1/4”- 20 x 7/8”
Self drilling screws
Short stem
roller
Top bracket
slide
End
stile
Center hole
Top
section
(2) 1/4”-20
Flange hex
nut
s