Filter
Top Products
18
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
Tools Needed:
Tools Needed:
Torsion End Bearing Brackets
IMPORTANT: RIGHT AND LEFT HAND IS ALWAYS
DETERMINED FROM INSIDE THE BUILDING LOOKING
OUT.
End bearing brackets are right and left. Using the
upper slots in the end bearing bracket, position above
the flagangle and secure the end bearing bracket to
the horizontal angle using (2) 3/8”-16 x 3/4” truss
head bolts and (2) 3/8”-16 nuts.
IMPORTANT: END BEARING BRACKETS MUST BE
ATTACHED THROUGH THE LOWER SLOTS ON 12”
RADIUS TRACK. 15” RADIUS TRACK MUST USE THE
UPPER SLOTS ON THE BRACKET.
Once the bracket is secured to the horizontal angle,
secure the top of the end bearing bracket to the jamb
using (3) 5/16” x 1-5/8” lag screw. Repeat for other
side.
Power Drill
7/16” Socket Driver
9/16” Socket
Ratchet Wrench
9/16” Wrench
Step Ladder
Left end
bearing bracket
(2) 3/8”-16 x 3/4”
Truss head bolts
Horizontal
angle
Upper slots used
on 15” radius
track
Lower slots used
on 12” radius
track
(3) 5/16” x 1-5/8”
Lag screws
16
(2) 3/8”-16
Nuts
Left end
bearing bracket
15
NOTE: If you have windload option codes 1121,
1122, 1123, 1124, 1125, 1141 and 1142, pushnuts
are required. If not, skip this step and continue with
step 16.
IMPORTANT: ACCURATELY POSITIONING THE
PUSHNUT ONTO THE ROLLER STEM IS CRITICAL.
ONCE THE PUSHNUT IS PUSHED ONTO THE ROLLER
STEM, THE TABS MAKING CONTACT WITH THE STEEL
SURFACE, WILL MAKE IT DIFFICULT TO REPOSITION
THE PUSHNUT.
NOTE: When positioning the pushnut onto roller stem,
ensure the tabs on the pushnut are pointing away
from roller stem.
Starting with the top bracket assembly, slide (1)
pushnut over the roller stem and push the pushnut
towards the outside edge of top bracket assembly
leaving 1/4” spacing between the outside edge of top
bracket assembly and pushnut.
Repeat same process for the end hinges on the left
hand side of door, then repeat same process for other
side of door.
Pushnuts
Tape Measure
Step Ladder
Pushnut
Roller
stem
Roller
stem
Pushnut
End Hinge
1/4” spacing
Top bracket
assembly
1/4” spacing