Filter
Top Products
10
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
Tools Needed:
Power Drill
7/16” Socket Driver
Sawhorses
Bottom Section U-Bar
NOTE: For door section identification see page 5.
Refer to the u-bar schedule to determine the required
number of u-bar(s), and placement on bottom
section.
Place the bottom section face down on a couple of
sawhorses or flat clean / smooth surface. Position the
u-bars according to the u-bar schedule, up against
bottom hinge leafs or just above the bottom brackets
on the bottom section. Center the u-bars side to side
on the section, and secure using (2) 1/4” -14 x 7/8”
self drilling screws at each end stile and center stile
location.
4
U-bar
Bottom
section
Bottom bracket
U-bar
(2) 1/4”- 14 x 7/8”
Self drilling screws
Bottom
hinge
leaf
U-Bar Schedule
Door height Section Position on section
Windload Options Code
1100 / 1101
1102 / 1103 / 1104 /
1123 / 1124 / 1125 /
1141 / 1142
1120 / 1121 / 1122 /
1140
1143 / 1144
8’ 3” to 8’ 9”
Bottom
Bottom
NA NA (1) Req. NA
Top
NA (1) Req. (1) Req. (1) Req.
9’ 0” to 10’ 6”
Bottom
NA NA (1) Req. NA
Top
NA (1) Req. (1) Req. NA
10’ 9” to
12’ 3”
Bottom
NA NA (1) Req. NA
Top
NA (1) Req. (1) Req. NA
12’ 6” to
14’ 0”
Bottom
NA NA (1) Req. NA
Top
NA (1) Req. (1) Req. NA
(2) 1/4”- 14 x 7/8”
Self drilling screws