Filter
Top Products
21
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
Tools Needed:
Tools Needed:
INSTALLATION
Place vice clamps onto both vertical tracks just
above the third roller. This is to prevent the
garage door from raising while winding
counterbalance springs.
FAILURE TO PLACE VICE CLAMPS ONTO
VERTICAL TRACK CAN ALLOW DOOR TO RAISE
AND CAUSE SEVERE OR FATAL INJURY.
Securing Door
for Spring Winding
Track
Vice clamps
attached to
track
(2) Vice Clamps
WARNING
21
Place vice clamps
above 3rd Roller
Counterbalance Cables
Vice Grips
3/8” Wrench
Step Ladder
Thread the counterbalance cables around the back
side of the left cable drum and verify that there is no
cable obstructions. Hook the cables into the drums.
Slide the left hand cable drum against the left hand
end bearing bracket and tighten the set screws in
the drum to 14-15 ft. lbs. of torque (Once set screws
contact the tube, tighten screws one full turn). Rotate
the left hand drum and torsion tube until cable is
taut. Attach vice grips to torsion tube and brace vice
grips against jamb to keep cable taunt.
Slide the right hand cable drum against the right
hand end bearing bracket and rotate drum until
cable is taunt. Tighten set screws in right hand cable
drum.
IMPORTANT: CHECK EACH CABLE, MAKING SURE
BOTH ARE SEATED PROPERLY ON THE CABLE
DRUMS AND HAVE EQUAL CABLE TENSION.
20
Left end
bearing
bracket
Cable in
position
Set
screws
Vice
grips
Jamb
Left cable
drum
Cable
Torsion
tube
Cable
hooked in
cable drum
Left cable drum