Filter
Top Products
17
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
Tools Needed:
Tools Needed:
INSTALLATION
Correct
Incorrect
(B)
Top
section
(2) 1/4” - 20
flanged hex nuts
14
With horizontal tracks installed you can adjust the
top brackets. Vertically align the top section with the
lower sections. Once aligned, position the top roller
in the adjustable slide(s), out against the horizontal
track.
For top bracket (A): Maintaining the slide(s) position,
tighten the (2) 1/4” - 20 flange hex nuts.
For top bracket (B): Maintaining the slide(s) position,
tighten the (1) 5/16” - 18 nut(s) to secure the slide(s)
to the top bracket base(s). Now lock each slide in
position using (1) 1/4” - 20 x 9/16” track bolt and (1)
1/4” - 20 hex nut through any aligning hole. Repeat
for other slides.
NOTE: If you have windload option codes 1124, 1125,
1142, or 1144: (2) slides are required to be adjusted
and tightened on each end of section.
Repeat for other side.
Adjusting Top Brackets
7/16” Wrench
1/2” Wrench
Step Ladder
Horizontal
track
Top bracket
slide
Short shaft
roller
Top bracket
slide
Top section
Horizontal
track
Long or
short shaft
roller
Top bracket
slide
1/4” - 20 X 9/16” Track bolts
and 1/4” - 20 flanged hex nut(s)
Top bracket assembly
(only for windload
option codes 1124,
1125, 1142 and
1144)
(A)
(1) 3/8”- 16 X 3/4”
Truss head bolt
(1) 3/8”- 16
Hex nut
Vertical
track
assembly
Horizontal angle
To install horizontal track, place the curved end over
the top roller. Align the bottom of the horizontal track
with the vertical track. Hand tighten the horizontal
track to the vertical track assembly with (2) 1/4”-20 x
9/16” track bolts and (2) 1/4” - 20 flange hex nuts.
DO NOT RAISE DOOR UNTIL HORIZONTAL TRACKS
ARE SE CURED AT REAR, AS OUTLINED IN STEP 23,
OR DOOR COULD FALL FROM OVERHEAD POSI TION
CAUSING SEVERE OR FATAL INJURY.
Level the horizontal track and bolt the horizontal
angle to the slot in the vertical track assembly using
(1) 3/8” - 16 x 3/4” truss head bolt and (1) 3/8” - 16
hex nut. Repeat for other side.
Remove the nail that was temporarily holding the top
section in place, installed in Step 12.
IMPORTANT: FAILURE TO REMOVE NAIL BEFORE
ATTEMPTING TO RAISE DOOR COULD CAUSE
PERMANENT DAMAGE TO TOP SECTION.
WARNING
13
9/16” Socket
7/16” Socket
Ratchet Wrench
9/16” Wrench
Level
Hammer
Flat Tip
Screwdriver
Step Ladder
Attaching Adjustable Horizontal
Track
1/4” - 20 Flange
hex nuts
Vertical
track
assembly
1/4” - 20 x 9/16”
Track bolts
5/16”- 18 x 5/8”
Carriage bolt(s)
and 5/16”- 18 hex
nut(s)