Filter
Top Products
14
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your local
yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com
Tools Needed:
Tools Needed:
9
Bottom Section
Center the bottom section in the door opening.
Level section using wooden shims under the bottom
astragal if necessary. Hold the section in the opening
while attaching vertical tracks.
Level
Wood Shims
Weather seal
Level
Header
Jamb
Bottom
section
Wooden
shims
Vertical Track Assembly
IMPORTANT: THE TOPS OF THE VERTICAL TRACKS
MUST BE LEVEL FROM SIDE TO SIDE. IF THE BOTTOM
SECTION WAS SHIMMED TO LEVEL IT. THE VERTICAL
TRACK ON THE SHIMMED SIDE, MUST BE RAISED
THE HEIGHT OF THE SHIM.
Position the left hand vertical track assembly over
the rollers of the bottom section. Make sure the
counterbalance cable is located between the rollers
and the door jamb. Drill 3/16” pilot holes for the lag
screws. Loosely fasten the vertical track assembly
to the jamb using 5/16” x 1-5/8” lag screws. Tighten
bottom lag screw securing vertical track assembly to
jamb, to maintain 5/8” spacing. Repeat for the right
hand side.
Loosen the 1/4” - 20 x 9/16” track bolts and 1/4”
- 20 nuts of each clip plates. The vertical track
assemblies will be adjusted and tightened in Step 13.
Hang counterbalance cables over vertical track
assemblies.
Bottom
section
5/16” X 1-5/8”
Lag screws
(your number of
lag screws may
vary)
Vertical track
assembly
Power Drill
3/16” Drill Bit
7/16” Socket Driver
Level
Tape Measure
Step Ladder
7/16” Wrench
Flat tip screwdriver
10
5/16” X 1-5/8”
Lag screws
Clip mount (your clip
mount quantity and
location may vary)
Vertical
track
Vertical
track
assembly
Bottom
section
Vertical track
Roller
5/8”
1/4” - 20 X 9/16”
Track bolt and
1/4” - 20 nut
Clip plate