Filter
Top Products
28
NOTE: The user must change the transmitter’s security
code before using the transmitter.
This code sequence is only necessary the fi rst time the
transmitter is used.
Overview: When changing the transmitter’s security
code, the user will have to hold the large button down
for approximately 10 seconds, then release the button
momentarily, and fi nally hold the button down again for
approximately 5 seconds.
CHANGING THE TRANSMITTER’S SECURITY
CODE:
1. Press and hold the large transmitter button for approxi-
mately 10 seconds until the transmitter’s LED begins to
blink rapidly. Once the LED starts blinking, release the
large transmitter button; the LED will turn off.
2. Press and hold the large transmitter button again
(LED will light) for approximately 5 seconds. After ap-
proximately 5 seconds the LED will begin to blink on
and off. Release the large button. The transmitter’s LED
will blink on and off three times indicating a successful
security code change. The transmitter is now ready to
be programmed to the opener.
TRANSMITTER PROGRAMMING:
To program transmitter:
1. Place the emergency disconnect handle in the manual door operated position. This is for safety reasons.
2. On the front cover of the opener, press and release the red program button; the opener will beep once, indi-
cating activation of the program mode. The opener will remain in program mode for 30 seconds.
3. Press and hold the desired transmitter button until; the opener beeps once. The transmitter is now pro-
grammed.
4. Return the emergency disconnect handle to motor operated position.
NOTE: No beeping response of the opener during the transmitter programming indicates a programming fail-
ure. Repeat programming 1-4.
NOTE: Programming failure can occur during the transmitter programming if the remote control is too close
to the opener during the programming sequence. Perform the programming with a minimum distance of six
feet between the remote control and the opener.
NOTE: The fi rst transmitter command, after programming, will only move the door through a six-inch up/down
cycle. Normal door operation will occur on the second usage of the transmitter.
NOTE: The opener can be activated by up to six remote control devices (including wall station, transmitter,
and keyless entry devices.) If a seventh control is programmed, the fi rst of the programmed controls will be
overridden and will no longer activate the opener.
CAUTION: For safety reasons, manually disconnect the door from opener using the emergency discon-
nect handle prior to erasing remote controls. To clear programming of all remote control devices, press
and hold the opener’s program button for approximately ten seconds. When the opener beeps three times, all
remote controls are erased.
HANDLE IN MANUAL
OPERATED POSITION
OPENER
LARGE
BUTTON
MOTOR IN UP POSITION
RED PROGRAM
BUTTON
Step 30: Transmitter Security Code
Change and Programming