Filter
Top Products
Table of Contents
System Requirements 2.
Important Safety Instructions 3.
Package Contents 4. - 5.
Tools Needed 6.
Available Accessories 6.
idrive™ Retro-fi t Installation 7.
Extension idrive™ Installation 7. - 14.
Pre-Operation Installation 15. - 29.
Operation 30. - 32.
Maintenance 33.
Troubleshooting 34. - 35.
Warranty 36.
Customer Service Number 36.
System Requirements
FCC and IC Statement
FCC Regulatory Information:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
IC Regulatory Information:
Operation is subject to the following two conditions: (1) this device may not cause interference,
and (2) this device must accept any interference, including interference that may cause undesired
operation of the device.
After installation is complete, fasten this manual near garage door. Perform monthly maintenance (see Mainte-
nance section page 33 of your idrive™ Installation Instructions and Owners Manual) and periodic checks, as
recommended.
NOTE:
Extension spring kit, model 3982 is designed for garage doors 7’-0” wide to 10’-0” wide and up to 8’-0”
high.
WARNING To reduce the risk of severe injury or death,
use this kit only with the following openers:
idrive™ Models 3660-372, 3661-372, 3662-372, 3760-372 or 3760N-372 can be
installed on a garage door with an extension spring counterbalance system and
standard lift track, ONLY when installed with the Infrared Safety Sensors Accessory;
Model 3965.
idrive™ Model 3660-372, 3661-372, 3662-372, 3760-372 & 3760N-372 can be
installed on a garage door with an extension spring counterbalance system and
standard 6” low headroom track, ONLY with the Low Headroom Kit, Model 3980 (not
included).
2