Filter
Top Products
NOTE: The user must change the wall station’s security code before using the wall station.
This code setting sequence is only required the fi rst time the wall station is used.
Overview: When changing the wall station’s security code, the user will have to hold the light button down
for approximately 10 seconds, then release the button momentarily, and fi nally hold the button down again
for approximately 5 seconds.
Changing the wall station’s security code:
1. Press and hold the wall station’s light button for ap-
proximately 10 seconds until the wall station’s LED
begins to blink rapidly. Once the LED starts blinking
release the wall station’s light button; the LED will
turn off.
2. Press and hold the wall station’s light button again
(LED will light) for approximately 5 seconds. After
approximately 5 seconds the LED will begin to blink
on and off. Release the light button. The wall station’s
LED will blink on and off three times indicating a suc-
cessful security code change.
The wall station is now ready to be programmed to
the opener.
Wall Station Programming
To program wall station:
1. Verify the emergency disconnect handle is in the
manual door operated position (lower position). This
is for safety reasons.
2. On the front cover of the opener, press and release
the red program button; the opener will beep once,
indicating activation of the program mode. The opener
will remain in program mode for 30 seconds.
3. Press and hold the wall station light button until the
opener beeps one time. The wall station is now
programmed.
4. Return the emergency disconnect handle to the mo-
tor operated position (upper position).
No beeping response of the opener during the wall
station programming indicates a programming failure.
Repeat programming Steps 1-4.
NOTE: Programming failure can occur during the
wall station programming if the remote control is too
close to the opener during the programming sequence.
Perform the programming with a minimum of six feet
between the remote control and the opener.
24
Step 23: Wall Station Security Code Change and Programming
LIGHT BUTTON
LED
HANDLE IN MANUAL OP-
ERATED POSITION
OPENER
LIGHT
BUTTON
MOTOR IN UP POSITION
RED PROGRAM
BUTTON