Filter
Top Products
Starting with the door in the fully open
position, place a 6” high object on the
fl oor progressively one foot from the left
side of the door, center of door and one
foot from the right side of the door. In
each position, activation of the opener
with the wallstation up/down button
should cause the door to move no more
than one foot, stop and then reverse to
fully open position. The same 6” high
object when placed on the fl oor, while
door is closing, should also cause the door to reverse.
WARNING WHEN PERFORMING THIS PART OF THE TEST, DO NOT PLACE YOURSELF
UNDER DESCENDING DOOR, OR SEVERE OR FATAL INJURY MAY RESULT.
WARNING IF THE OPENER DOES NOT RESPOND PROPERLY, OR FAILS THESE TEST,
HAVE A QUALIFIED SERVICE PERSON MAKE NECESSARY ADJUSTMENTS/REPAIRS. FAILURE
TO MAKE ADJUSTMENTS COULD RESULT IN SEVERE OR FATAL INJURY.
27
Step 28: Photoelectric Obstruction Sensor Test
12”
6”
12”
Manually position the door to the desired pet opening height (between 8” and 30” above ground) and return
disconnect handle to the motor operated position.
2. Simultaneously depress the pet and up/down buttons on the wall station. The opener will beep once. The
pet button is now programmed to automatically open the door to this custom height.
NOTE: The opener will NOT accept programmed pet lock position if door is below 8” or higher than 30”.
NOTE: Activation of the normal install routine will reset the pet position to the default eight inch target
height. For use of the pet button see Operation section.
After installing the opener, the door must reverse
when it: contacts a 1-1/2” (38mm) high object (or a
2 x 4 board laid fl at) on the fl oor. To verify proper
operation:
1. Using the wall station, activate the door to the fully
open position .
2. Place a 2 x 4 board laid fl at on the garage fl oor
under the door path.
3. Activate the door to the closed position with the
wallstation; upon contacting a solid object, the door will stop, then reverse direction within two seconds and
travel to the full open position.
If the door does not respond to the required tests, remove 2 x 4 and repeat install routine making sure the
door is in the fully closed position prior to activation. If problem persists contact Wayne Dalton Customer
Service (888) 827-3667
WARNING IF OPENER DOES NOT RESPOND PROPERLY AND FAILS EITHER OF THE
TWO TESTS (28 AND 29), DOOR MAY CAUSE A SEVERE OR FATAL INJURY. HAVE A QUALIFIED
Step 29: Contact Obstruction Test
CENTER OF
DOOR
2 X 4 LAID FLAT
ON FLOOR