Filter
Top Products
NOTE: RECEPTACLE COVER MUST BE INSTALLED
IN-BETWEEN THE LIGHT FIXTURE AND THE CEILING
IMPORTANT! The light is turned on and off by an infrared (IR) signal sent from the opener to the light.
Therefore, the light must be mounted in a location where it can always “see” the front face of the opener.
Locate a duplex receptacle within line of sight of opener, when the door is in the open position.
Disconnect power to the receptacle at the fuse/breaker box before proceeding.
WARNING TO REDUCE THE RISK OF ELECTRICAL SHOCK, THIS EQUIPMENT HAS A
GROUNDING TYPE PLUG, THAT HAS A THIRD
(GROUNDING) PIN. THIS PLUG WILL ONLY FIT
INTO A GROUNDING TYPE OUTLET. IF THE
PLUG DOES NOT FIT INTO THE OUTLET, CON-
TACT A QUALIFIED ELECTRICIAN TO INSTALL
THE PROPER OUTLET. DO NOT CHANGE THE
PLUG IN ANY WAY.
WARNING TO AVOID ELECTRICAL
SHOCK, DISCONNECT POWER TO THE RECEP-
TACLE AT THE FUSE/BREAKER BOX BEFORE
PROCEEDING.
WARNING DO NOT INSTALL THE
LIGHT FIXTURE INTO A RECEPTACLE WITH A
METAL FACEPLATE.
NOTE:
Door must clear light fi xture when the door
is in the open position. There must be no obstruction
between the light fi xture and the opener for light fi xture
to work properly.
CEILING MOUNTING
Remove the center screw in the receptacle cover. Hold-
ing receptacle cover in place, insert light fi xture into
the receptacle that has the ground hole farthest from
center screw hole. Remove center hole plug from light
fi xture to expose the screw hole. Secure light fi xture to
receptacle with a #6-32 x 3/4” phillips pan head screw.
Replace hole plug into the screw hole in the light fi x-
ture.
NOTE: For temperature protection, the hole
plug must be in place prior to using the light fi xture.
Loosen thumb screw and rotate light fi xture’s bottom
section to align the receiving module, side to side,
with the sending LED on the opener. Re-tighten thumb
screw, don’t over tighten. Rotate receiving module to
align, up and down, with the sending LED.
Screw a maximum 75W light bulb into light socket and
snap diffuser into light fi xture. Turn receptacle power
back on at fuse/breaker box. The light should blink
one time when the power is re-established.
NOTE: An accessory power outlet receptacle (600 Watt
Maximum) is provided on the light fi xture.
Step 17: Light Fixture Installation
17
DUPLEX
RECEPTACLE
LIGHT FIXTURE
DIFFUSER
HOLE PLUG
#6-32 X 3/4”
PHILLIPS
PAN HEAD
SCREW
75W (MAX)
LIGHT BULB
(NOT INCLUDED)
ALIGN
RECEIVING
MODULE
AIM AT
IR LED
SENDING IR
LED
OPENER
THUMB
SCREW