Filter
Top Products
NOTE: Skip this step if installing only one idrive™ opener.
Switch Settings: Light Fixture
If installing more than one opener in the same garage, the light fi xtures can be set to function only with a selected
opener. Leaving the light fi xture as is from the factory may cause all light fi xtures to light when any one of the
openers are activated. The opener jumpers and light fi xture switches need to be matched to allow for the opener
to activate a specifi c light fi xture. To adjust switch
location on light fi xture, slide switches on top of light
fi xture housing.
Jumper Settings: Opener
On the right side of the opener, insert jumper(s) provided
in the hardware pack, to match the switch setting of the
light fi xture.
16
Step 16: Multi-Opener/Light Fixture Programming
When the light fi xture switches and the opener jumpers are matched, the light fi xture will respond to its
matched opener.
Jumper Settings
Detail
Opener
Detail
-A- = -A-
-B- = -B-
-C- = -C-
-D- = -D-
Light Fixture
-C-
SWITCH 1 (ON)
SWITCH 2 (ON)
NO JUMPERS
FOR PINS 1 & 2
PIN 1
PIN 2
PINS 1 & 2
SWITCHES
LIGHT FIXTURE
-A-
SWITCH 1 (OFF)
SWITCH 2 (OFF)
(FACTORY
SETTING)
-B-
SWITCH 1 (ON)
SWITCH 2 (OFF)
-D-
SWITCH 1 (OFF)
SWITCH 2 (ON)
-A- -B- -C- -D-
-A- -B-
-C-
-D-
OPENER